The overall status is based on the most severe status of all contributors
Status values are HEALTHY, MARGINAL, or DOWN, depending on whether thresholds established by switchStatusPolicySet have been exceeded. Report Time Switch Name IP address Switch State: HEALTHY, MARGINAL, or DOWN Duration: hours and minutes (HH:MM) the switch has been in the current state Power supplies Temperatures Fans WWN servers (dual-CP systems only) Standby CP (dual-CP systems only with HA enabled) Blades (bladed systems only) Flash Marginal ports Faulty ports Error Ports This command displays the following information: the overall switch status, and the status of the following contributors:
#Brocade san switch rport error license
In addition, users with a Fabric Watch license are able to view a listing of unhealthy ports that includes the port index number, the port name, and the port status. Use this command to display the overall status for a switch. Switchstatusshiw Switchshow Sfpshow porterrshowīASIC TROUBLESHOOTING COMMAND : EXPLANATION : MOHAIDEEN ABDUL KADERįor doing basic hardware troubleshooting in Brocade Switch we can use the below commands, I have briefly explained about the commands & I have kept one example to identify the issue with the switch 1. (No special process, just normal like you d clean up your own directories Just delete everything under support.5 MINUTES INITIAL TROUBLESHOOTING ON BROCADE SAN SWITCH BROCADE F. Website: International phone: 00800-2834-2733Ĭlear the folder prior using the USB drive. Brocade support can provide the batch file to customers needing it.Ĭontact Brocade Support: Email: America phone: 1-80
#Brocade san switch rport error install
This can be accomplished through a manual process by which the correct folders are created or through the use of a batch file.īrocade support has created a batch file that will reformat the USB drive and install the proper directory structure. Recovering an improperly formatted USB flash drive only requires installing the correct directory structure as shown in the "cause section above. Additionally, some flash drives were formatted with the proper directory structure, but also include extraneous files in the support sub-folder. Refer to the image below for location of the WO number.įor Issue 2. These can be identified by the marking on the USB drive.Īffected units will have a WO# of either PMK1625U27 or PMK1625U28. The flash vendor has confirmed this issue is limited to two lots. Normal functional operation of the switch will not be impacted. Without this directory structure in place, the USB drive will not be accessible to FOS and the use of the USB drive for these actions will not be possible.
The required directory structure consists of a top level brocade folder, with four sub-folders as shown below. Error: Device is not found or not formatted.Ī properly formatted drive will display the following message when enabled: In the event the USB drive is not formatted properly, a warning message will be displayed on the terminal when the enable command is issuedįail to enable USB storage device. The USB drive is used for FOS upgrades and saving logs and system configurations. Some 4GB USB drives were shipped without this formatting implemented and thus are not usable as shipped.
The USB Flash drive that ships with Brocade SAN products requires a specific directory structure to be in place in order to be recognized by Brocade Fabric OS (FOS). The USB Flash is enabled through the CLI command usbstorage enable .įor Issue 1.
0 kommentar(er)
